Available in any quanitity by special order, contact for details.
The new Pixel Controller Electron is a recommended for most projects.
This controller from NLED packs many features into a small form factor. It supports various communication methods for direct control of the outputs, such as USB, TTL serial, or DMX-512. But the focus of the design is the powerful stand-alone color sequence support. The software NLED Aurora Control, allows a user to interface with the controller and create custom color sequences, including custom POVs, that can be uploaded to the controller over USB. The controller supports up to 512 channels(170 RGB pixels) and will run the loaded color sequences without any data or computer connection. The small size, low current, 3-axis accelerometer, and dynamic stand-alone color sequences make this controller a good choice for wearables, hoops, staves, poi, bikes, and other controllable pixel based projects. The device currently supports several of the most popular pixel chipsets, with the ability to easily easily update the firmware with new features and chipset support.
Supports 512(170 RGB Pixels) channels in stand-alone, USB Live Control, DMX-512 Control, and Serial control. Note some chipsets allow 550 pixels to be controlled over USB Live Control.
Currently Supported Chipsets: WS2801, WS2803, WS2811, WS2812, WS2812B, LPD6803, LPD8806, LPD1886, TM1803, APA102. Others may work if they use a similar control scheme. Please contact us if you would like additional pixel chipset support.
NOTE: Accelerometer features are now an added-option, please select the option below or the controller will not include one.
- Pixel Controller Ion with choice of connector options, Described Below
- 6" double strand wire for the button
- Momentary push button(PCB mount)
- Clear shrink tube that covers the entire PCB(with USB and Output access from each end)
- Optional Free 3 or 4 pin JST-SM harness(matching set)
Optional 3-Pin JST-SM Inline Controller Option With 3-Pin JST-SM connectors and PCB Mounted Button. For use with WS2811, WS2812, WS2812B, LPD1886. Ready to use, just connect the LEDs and power supply, no soldering required. The controller side has the female JST-SM recpetacle and it comes with a separate matching male. Select the checkbox below to enable this option. Accelerometer is NOT installed for Inline models.
Optional 4-Pin JST-SM Inline Controller Option With 4-Pin JST-SM connectors and PCB Mounted Button. For use with WS2801, WS2803, LPD8806, LPD6803, APA10, APA104. Ready to use, just connect the LEDs and power supply, no soldering required. The controller side has the female JST-SM recpetacle and it comes with a separate matching male. Select the checkbox below to enable this option. Accelerometer is NOT installed for Inline models.
Note: There are 3 connector options for this controller, Unpopulated/Solder Pad(User solders on their own connector, or the optional JST-SM harness), right angle header(polarized), or screw down terminal. JST-SM connectors are available for free, select your prefered type(3 or 4 pin) from the drop down below. If you would like anything soldered(such as the button or JST-SM harness) please make a note during checkout or send an email with your notes.
This product was added to our catalog on Thursday 03 July, 2014.